Fluke i310s Current Probe

Tính năng chính

Current Ranges: 30 A and 300 A AC_RMS or ±45 A and 450 A DC
Measuring Ranges: ±45 A and 450 A dc
Output Sensitivity: 10 mV/A (40 A) to 1 mV/A (400 A)
Resolution: ±50 mA (40 A) to ±100 mA (400 A)
Load Impedance: > 10 k Ohms and £ 100 pF
Frequency Range (small signal): DC to 20 kHz (- 3 dB)
Phase Shift below 1 kHz, < 2 degrees
Temperature Coefficient: ±0.1% of reading / °C
Power Supply: 9 V Alkaline

Tổng quan sản phẩm: Fluke i310s Current Probe

The i310s current probe is based on Hall Effect technology for use in measurement of both DC and AC current. The i310s may be used in conjunction with oscilloscopes and other suitable recording instruments for accurate non-intrusive current measurement.

Thông số kỹ thuật: Fluke i310s Current Probe

Electrical Characteristics
Current ranges	30 A and 300 A AC rms or ±45 A and 450 A DC
Measuring ranges	±45 A and 450 A DC
AC rms or DC	±45 A and 450 A
Inrush current	600A AC rms MAX
Output sensitivity	10 mV/A (30 A)
	1 mV/A (300 A)
Accuracy (at +23°C)	(30 A range)	±1% of reading ±50 mA
	(300 A range)	±1% of reading ±300 mA
Bandwidth to meet accuracy specification	1 kHz
Phase shift below 1 kHz	< 2 degrees
Resolution	±50 mA (30 A)
	±100 mA (300 A)
Load impedance	> 10 k Ohms and ≤100 pF
Conductor position sensitivity	±1.5% relative to centre reading
Frequency range (small signal)	DC to 20 kHz (-3 dB)
Phase shift below 1 kHz	< 2°
Temperature coefficient	±0.1% of reading / °C
Power supply	9 V Alkaline, MN1604/PP3
Battery life	30 Hours, low battery indicator
Working voltage (see Safety Standards section)	300 V AC rms or DC
General Characteristics
Maximum conductor size	19 mm diameter
Output connection	Safety BNC connector
	Supplied with safety 4mm adaptor
Output zero	Manual adjust via thumbwheel
Cable length	2 metres
Operating temperature range	-10 to +50°C
Storage temperature range (with battery removed)	-20 to +85°C
Operating humidity	15% to 85% (non-condensing)
Weight	250 g
Safety	IEC 61010-1, Pollution Degree 2
	IEC 61010-2- 032: CAT III 300V
	Use of the probe on uninsulated conductors is limited to 300 V ac rms or dc and frequencies below 1 kHz.
EMC Compatibility	IEC 61326-1: Portable Electromagnetic Environment